Could someone please advise what buffer and weight comes with the PSA AR-15 COMPLETE MOE+ EPT PISTOL LOWER WITH MAXIM PDW BRACE? Thank you in advance for your help!
1 Like
Iām hoping this is a bump.
Hi all, I have the PSA 16" pencil profile upper, with the 13.5" Lightweight M-Lok Rail. It has a QD socket near the chamber on the rail on the 3:00 and 9:00 positions, but when I tried using my QD sling swivel in it, the shaft on the swivel was too long, causing it to hit the barrel and not lock in all the way. Has any one else had this problem, and which QD sling swivels do you use that you have found work? Thanks!
Question about AAC 62gr FMJ ammo: Is this projectile steel penetrator like ss109 or is it standard fmj like the 55gr? I canāt seem to get an answer anywhere.
1 Like
Question about AAC 62gr FMJ ammo: Is this projectile steel penetrator like ss109 or is it standard FMJ like all the 55gr out there? I canāt seem to find an answer.
Howdy gang! First time posting on this thread. Anyhoo, I just received my āMerry Christmas to me presentā, the PSA PA-15 16" Nitride M4 Carbine 5.56 MOE EPT AR-15 Rifle, OD Green. This is my very first AR - Iām more familiar/comfortable with the AK side - and Iām already in the process of personalizing it. My question right now is, can anyone answer/confirm for me, is the BCG nitrided and/or coated or not? (Iāve been reading that the BCG is one spot to strongly consider upgrading. Thanks for any and all help. Keep the faith and Iāll catch you on the flip side!
1 Like
Has anyone tried putting a magpul handstop on the PSA 8.5ā 300 blackout upper? Iāve tried and the gas block blocks the screws.
I have a PSA upper. The only marking I can find on it is āFREEDOMā near the end of the barrel. I know it is 5.56 or .223, if it says āFREEDOMā does that help identify which one it is?
1 Like
I hope the wise elders have not abandoned this thread. I am an unwise, wisecracking elder, and so, am useless.
The chambering SHOULD be stamped on the barrel but may be concealed by the furniture. On my Freedom upper, itās at the 12 oāclock position not far behind the flash hider. Hereās a (crappy) photo.
16" carbine, Govāt profile, 5.56, 1:7 twist.
2 Likes
Iāll have to take the furniture off to make sure
1 Like
Should be standard fmj. Usually ss109 is marked with a green tip
You need a crushed washer or timing washers.
I can be wise sometimes
Am an avid handgun pistol range shooter mostly 9mm. Looking to getting into AR Pistol range shooting. Leaning towards 300 Blackout suppressed. Would like recommendations on a good PSA AR pistol entry point and suppressor.
I just recently bought the PSA AR-15 āSTEALTHā STRIPPED LOWER RECEIVER and Iām looking to add onto it with a rifle build kit. What would you guys recommend? Iām looking for magpul attachments if possible.
Good question, I have same issue
Finished getting all the parts to build my first ar starting with the CHF Pin Weld PSA upper this is the parts everything is acquired just gotta slap it together. Curious on if I did well or should have just bought a complete rifle
Personally, I like that little bit of pride knowing that I assembled my rifle, when I am holding it.