I’m looking for aftermarket ambi charging handle that actually fits psa ar 10. Breek arms war hammer doesn’t fit. What are you guys running in your PA 10s. Thank you.
What do you mean it doesnt fit? Are you using an ar15 CH instead of an ar10? Any ar10 specific CH ahould fit.
It’s an ar10 handle. It’s super tight fit. I can see where it’s rubbing on the top end by the gas key.
Breek’s website says the Warhammer’s compatible with DPMS Gen 1 High and Low, but not DPMS Gen 2. Could that be your issue?
I believe so. Says it on the back of the box also, just didn’t realize it until I installed it. Any ideas as far as modifications to get it to not be so tight? Pretty sure I’m SOL on returning it since I’ve installed it already and has some minor wear. Was debating removing a little material from the top gas key end of handle where it seems to be the only rub marks.
PSA ar10s are not DPMS low but very close. They are not G2.
1 Like
If you think you’re SOL on a return I would certainly try Dremel modding the CH.
Hope this helps
3 Likes
Thank you.
1 Like
I had to sand down the bump in front and it works great now
1 Like
Welcome aboard.
1 Like