I’m happy to hear my suggestions were helpful! With an aggressively over-gassed setup, all you can really do is give the BCG more mass to delay the bolt opening and then more spring to slow down that increased mass. The cost, complexity, and difficulty of having a handful of springs and buffer weights is low and easy enough it never hurts to have some lying around to test with.
4 Likes
Welcome to the PSA community @Mikkolangot 
1 Like
For those of you folks that don’t want a Adj. GB.
Yankee Hill makes a .750 Suppressor GB, that comes with a “50%” port size smaller than a typical GB.
I don’t have a Pin Gauge small enough to actually measure the specific size… but a .061 will not go through the GB’s gas hole.
That way you can drill it larger to suit your needs.
https://yhm.net/new-products/suppressor-gas-block/
For $21, it is a pretty inexpensive way to alter your gas flow.
2 Likes
i have a wolff extra power spring “10% or 15%” and h1 buffer on my midlength, idk the ejection pattern or anything but it feels nice, “softer”