Since my move south from the 'Ville, my two PSA rifles have been in bags for reassembly. The barrels had been shipped to 300 Below for Cryo-normalizing, then had the Riflespeed gas regulators installed with the machined/pinning process.
I located my torque wrenches, barrel nut bit, the action vice block, etc.
Reassembly was not as complicated as I thought, so here they are.
Haven’t found my box with all my cans and probably the scope for the 6.5, but I’m sure it’s underneath my pile of ammo somewhere.
5 Likes
Couple of notes. With the rifle speed pinned, you will need to pin the gas tube to the Riflespeed block prior to seating the barrel to the upper. Your torque wrench will have to come up from below to get around the gas tube for torquing the barrel nut.
1 Like