I purchased both flat bow and curved. I noticed the curved trigger has two set screws, reading the package l found nothing about them. After installation l noticed a little play so l turned them down untill the play was less and checking the safety. Is this what they are for? Flat trigger does not have this yet a little play (up/down not side to side). I had a Nic Taylor grip adjustment screw l installed, adjusting to a sweet spot/safety check good to go! I’m getting a 3lb break now before it was a little over 3 1/2. Ran both yesterday…OMG! SWEET! What l don’t understand they are incapsulated drop in not mil spec which l understand the main use of a grip adjustment scew. Mind blown but a happy shooter!
2 Likes
Yes, that is precisely what you should have done.
Awsome thank you
Most mil spec drop ins dont have an adjustment. Typically # adjustment will be on a list when you open for install (at least the rise armament i used had one). Myself personally ill take a good clean reset over actual # adjustment for target reacquisition purposes…as long as its not an astronomical number for the actual break in the trigger itself…happy shooting bro. I wish psa would come out with some fcgs for the dagger that would compete with all the other big names
2 Likes