In my previous PA 10 builds, I used the PSA Custom handguards. As they don’t seem to be available any more, what would be a similar style from another source that you would recommend? I’m using the Gen3 upper.
Anything DPMS Low is going to be real close. (Fraction of a hair close). PSA uses their own proprietary height but it is basically DPMS low.
Thanks! Will PSA bring back their hand guards? I really liked them.
Right now i beleive they are using them on full guns.
Ok. Too bad. Thanks for the info.
no offense…my factory one does not match up…about 1 to 1.5 mm low.
My advice is look at MI (Midwest Industries)… “from what I have read”… they match up perfectly to the G3s… I am waiting to get one soon I hope… will post up results when it happens.
Thanks ETHRON1
I picked up one from Aero Precision. Looks good to me as far as matching up. Here is an “Almost” done build (the top one) with the AP handguard. I just need to add the bolt carrier group and I’m done. I’ve since added Magpul pop up sights. Both are PSA uppers/lowers. The top is a 16" and the bottom a 20"
2 Likes
Looks good…
Thanks!
Interesting. Can you post a pic? I’d like to see it.
I did earlier above.
that reply was to @ETHRON1 .
1 Like
the handguard it self… I don’t have one yet…working on it though.
The finished product! I used an Aero handguard. It was a near perfect match for height. It has Magpul sights, magazine, and foregrip. The optics are Sigs new red dot.
2 Likes
Sorry I misunderstood… I’ll get a Pic taken
Does anyone know if Wilson combat AR-10 rails will fit gen 3 pa10 upper
If it specifies that it is for a DPMS Low receiver, it will be close.
1 Like
Did you ever receive your MI handguard? How did it match up to the PSA G3 upper?
Welcome to the forum @Your1Savior 
1 Like