Okay I have 2 problems! I bought lower kit an stripped ghost receiver so everything was going good until first the screw on my trigger guard got stripped with like 2 turns an also cant really get it out so how can i go about getting it out an what about getting a new screw?? Also 2nd problem is when putting in my drop in trigger the bottom anti walk screw went in just fine but the second top 1 will not slide in just like the first 1 so do i need to hammer it in or is it jus suppose to slide in? So would the hole be a little small on the lower reciever, or is that jus how it is an jus need to hammer it in or should it just slide in just like the first bottom one did?? Thanks for all the help in advance!! Hope pictures may help
2 Likes
Second pic woulnt let me post both at same time but actually think it might be the anti walk pin that might be off cause the other 1 will go in both holes so do i need to hammer the other 1 in or contact PSA an see if they will send me 1 replacement anti walk pin or something thanks for all the help in adavnce!!
1 Like
Try a different bit…Metric or standard i had the wrong set out at first. Forget which it is.
2 Likes
If it is stripped you will need to go buy and easy out bit from you local hardware store. But try the correct allen wrench first.
As for the pins, i have always lightly tapped them in. You may have to jiggle the trigger to get the holes to align.
2 Likes
Use a torx bit on the trigger guard screw. I don’t remember the size but it’s happened to me more than once and that always worked.
1 Like