I have a new PSA Dagger Micro C1 and I have been enjoying shooting it. I put a Sig Sauer Romeo Zero on it and I started to have failure to extract issues. I used the shorter screw that came with the pistol and I don’t see any issue with it hitting the extractor plunger. I cleaned the gun and properly oiled it. I was shooting Blazer Brass 115 gr ammo. I will try some 124 gr next and see if that is the issue. The final step will be to remove the red dot and see if that helps. Would the next step be to replace the extracor (I can just put a Glock 43x extractor in correct?) or should I just send it back to PSA?
Don’t replace parts randomly. Remove the optic and fire it again, if the issue persists then send it to PSA, if it doesn’t then it’s your optic and/or screws.
2 Likes
If you take the backplate off and try removing the extractor plunger, it should immediately tell you if the screw is contacting.
I had that issue on my RXM. By looks, it wasn’t protruding. Plunger wouldn’t come out.
1 Like