https://palmettostatearmory.com/psa-pa-10-lightweight-m-lok-15-free-float-handguard.html
This one to be specific. Thanks in advance for the help!
I was looking for a replacement because I bought the handguard off of someone that doesn’t have the included hardware.. Sorry, should of been more clear.
2 Likes
They dont sell them independently. Unless it uses a standard GI barrel nut all free float handguards need the one it comes with.
I wonder if I can reach out to someone at PSA and possibly get a replacement.
You might could contact KAK, see what the diameter of this is:
The handguard you have uses a “pinchbolt” mounting. If the diameter of KAK’s nut is the same as the I.D. of your handguard, it’ll almost certainly work. KAK is usually very helpful.
They also have an aluminum version, similar price. It’s only got to be a minimum of 33lb-ft and a maximum of about 50lb-ft. That spec is for Milspec nuts, to make sure the slots line up for the gas tube and block going straight into the receiver. Un-necessary to crank it with this type setup. Nevermind - the aluminum is AR-15. mea culpa.
I loves me some PSA, but I think you might be wasting your time trying to get them to sell you that part if they don’t have a separate SKU.
