See photo. Dose any one else have this issue
You running a red dot?
Yes
Did you check and file down the screws on install?
2 Likes
I didn’t. What dose that have to with the firing pin housing damage. Lol I’m not sure is that’s what it’s called. But it’s the plastic on the back side of the slide
1 Like
It has a lot to do with it. If the screws were too long that’s exactly the area where the screws deform the Striker housing.
4 Likes
I’d take it apart and look. You likely won’t be able to get the striker housing to come out without removing the dot. Put it in a bag when removing the the back plate that spring launches on disassembly.
I have one that the striker housings are cracked on the top side because of the long screws. Runs just fine though so I haven’t called CS or anything, got all mine when they were new on the market and we didn’t know at the time it was an issue.
2 Likes
That’s interesting. I don’t remember how the the screw are. But every thing works. But I wasn’t sure would this cause a issue in the future
Got it thanks
The Greenville Store actually installed that optic because I bought it in store and they’ll install optics if you purchase them there. They weren’t aware of the issue yet either.
mental note, check my dagger out of paranoia to make sure the same thing isn’t happening.
1 Like
That would be a good idea.
3 Likes