Hornady lead pistol bullets are pre-lubricated and cold-swaged for total uniformity and balance. Hornady’s exclusive knurling system retains lubricant over the entire bearing surface to reduce leading in your barrel. For cowboy shooters, authenticity is a strict requirement. Thats why Hornady Cowboy bullets are made to SASS (Single Action Shooting Society) specifications, and are held to the same stringent production standards as all Hornady products. Hornady lead bullets are swaged lead, not cast. This guarantees uniformity and balance for increased accuracy. The special knurling holds an even distribution of lubricating wax over the entire bearing surface.

FLAT POINT BULLETS

The flat point shifts the center of gravity to the bullets rear for increased stability and accuracy. This ensures proper positioning in authentic revolvers, with no unwanted nicking of primers as the cylinder turns.

SPECIAL KNURLING AND GREASE RING

The knurling system holds an even distribution of lubricating wax over the bearing surface of the Cowboy bullet. The result is less leading.

For the best selection of bullets and reloading supplies from Hornady and other top suppliers, shop Palmetto State Armory!

Report incorrect product description

Reviews

Q & A

Retail Stock

Compliance

Shipping Restrictions

It is the customer’s responsibility for understanding state laws regarding all purchases made. For a comprehensive list of all Shipping Restrictions, please refer to our Shipping Restrictions By State Page found Here.

WARNING: Handling firearms or firearms parts can expose you to lead and other petroleum products known to the State of California to cause cancer, birth defects, or other reproductive harm. Wash hands thoroughly after handling. For more information go to www.p65warnings.ca.gov (CA Health and Safety Code Section 25249.6).

All NFA Rules Apply

These items are controlled by the U.S. Government and authorized for export only to the country of ultimate destination for use by the ultimate consignee or end-user(s) herein identified. They may not be resold, transferred, or otherwise disposed of, to any other country or to any person other than the authorized ultimate consignee or end-user(s), either in their original form or after being incorporated into other items, without first obtaining approval from the U.S. government or as otherwise authorized by U.S. law and regulations.