Ouch, i stand corrected.
1/8 inch Inconel wielding wire cut to 1 1/16 inch works perfectly as a replacement for the front grip roll pin. No grooves, but Iāve been shooting for a month with close to 1,000 rounds and it hasnāt walked at all. I suspect that a 1/8 inch stainless steel dowel rod available on Amazon in 1 inch or 1 1/4 inch would work as well, but either it would be slightly under sized or you would have to cut it to length. I used a Dremel cutting wheel to cut the Inconel and it was free from my neighbor who does contract high end wielding for the drilling industry.
The trigger pin is fine as is unless you want all stainless colored pins. Zev Technologies sells a titanium trigger pin and a titanium ejector housing pin for $11 each. I replaced all for easy Glock tool disassembly.
Inconel would be much stronger and durable than any stainless.
1 Like
Mag well info 
Checked out that magwell, It looks cool. Gonna have to pick one up. Thanks again Jammo
1 Like
I have a similar issue as another person on this FAQ where the screws for the RMR plate are not fitting in the drilled holes for the slide, they continue to spin and plate does not lock down. Afraid Iām going to strip the threads in the upper. Not sure how to proceed.
Product is a Dagger Compact w/ SW2 Extreme Carry Cut.
You dont need a plate. What optic are you trying to use?
1 Like
Welcome to the forum @Harlequin
1 Like
Just trying to figure out if I need different screws than the ones provided. My big splurge was on the pistol, I havenāt decided on an optic yet, since they cost as much as the pistol. I saw earlier the screws are 6/32, just need to confirm the screw holes in the slide for the compact match that so that when I do get an optic I know itāll fit.
EDIT 1: Matching the screw size reference
EDIT 2: Auto-correct sucks
Thanks!
Re there any future plans for updated color options, really want a full size in white
1 Like
Have not heard of any.
1 Like
Figured the FAQ section would be most relevant thread for this, but I have searched in the forum and on the product listing on the site and I canāt seem to find an actual factual spring weight for the stock recoil spring. We got a possible answer(18lbs) but nothing official to my knowledge. Can we get a wise one to confirm?
Dunning-Kruger effect at its finest.
1 Like
Needed thisā¦Almost goofed up an bought 15 round mags for a full size s
2 Likes
If you donāt find your answer in FAQ then feel free to ask @timdoggg85
1 Like
So is it safe to assume holsters fit both the compact and full size s frames?
And if I have a light on there I really just need to focus on getting a holster for the light right.
Any recommendations for IWB holsters for the full size s that work with the Olight Baldr Mini.
Also, shouldnāt the dagger slides have a loaded chamber indicator?
They do have an LCI of sorts. Just hard to see the difference.
1 Like
Both frames are 19 length so you only need to worry about that dimension unless you run an X slide on it. Holsters arenāt touching the grip, so a lot of G19/X/45 holsters are good to go.
Going to depend on IWB style you want. I like the sidecar style mag caddy holsters. If Trex doesnāt make the new Sidecar for a G19 with that light, try Tier 1 Concealed.
1 Like
This post is saying there is no LCI, can anyone confirm, not seeing any indication on mine, looks the same regardless. Dagger LCI